BODAN® Highway/Railroad Grade Crossing System

The top of the edge beam component of the BODAN® crossing system is modified to accept the 2.5" diameter LED fixture. The 1/4 x 1" slot molded into the side of the edge beam provides a wire channel for the conduit.

Close-up plan view of the LED fixture and cover plate. The cover plate is sized for the width of the edge beam and secured in place with "tech" screws.

Sealing conduit wire in channel of edge beam using electrician's putty.

<BODAN                 CD Offer

Close-up view showing the connector wire with LED fixture and leads. Twist nuts used to join the wires are not shown here.


After the edge beams and LED fixtures are completed, field panels are installed. The vertical rubber strip used between the edge beam and the panel protects the wiring during installation.


Crossing fully lit, viewed from end of crossing prior to paving.
 
 Projects         Drawing.pdf